The striker is the shaft that moves in and out of the door to penetrate into the jamb the diameter is 1 inch.
Standard door handle hole size australia.
Most of the current locks require the standard 2 1 8 bore.
The hole diameters are 2 and 1 8 inch and 1 inch respectively.
You need two different hole saws to create the perfectly round holes in the face of the door and the smaller hole in the edge of the door.
The code prescribes.
If one wants to replace their locks on doors that have smaller diameter holes there are 2 options.
Regardless of the size of the door the australian standard as 1428 1 design for access and mobility part 1.
In most cases the door set which is inside of the door and controls the door latch.
Standard door handle height.
This is around waist height for the average adult.
General requirements for access recommends that the height of the handle should fall within 900mm and 1100mm above the floor.
The international building code provides a standard for a doorknob height.
Even though different countries have their standards.
Lock bore the diameter of the hole for the lock body.
The last thing you want to use is a jigsaw.
These factors may include door handle height code in a particular country purpose and type of handle.
The standard bore is 2 1 8.
Measure from the center of the door knob hole to the edge of the doorway to find the size of the door set.
Many older doors had bores that were been smaller.
Typical door handle height.