The end wall flashing provides protection where a roof intersects with a vertical wall.
Steel roof end wall flashing.
I m going to install one between each panel directly in the center.
It is designed to cover and protect roof to wall intersections from water infiltration.
It s very important to make sure that you grab the z channel that s below and make sure that you re in the outside leg of the z channel.
Roof to wall flashing is bent at a 110.
The gibraltar roof to wall flashing is made from trusted 28 gauge galvanized steel.
The wall side of the flashing can be covered with siding or counter flashing and outside closures are necessary to seal between the flashing and the panel.
The flashing needs to be installed before installing the roof shingles the metal flashing is formed with a hook edge and cleated on 12 centers the flashing extends up the wall at least 4 the flashing extends onto the roof a minimum of 2 inches 4 inches is preferable in more severe climate areas.
To read pdf files you need the adobe acrobat reader 6 0 or higher.
Endwall flashing is to be used where there is a lean to type roof sloping away from the vertical wall.
Used in conjunction with closure strips or butyl tape it reliably protects against water infiltration.
Specify which trim piece is needed and the roof pitch when ordering.
With the end wall flashing in place i use stitch screws to attach it to the z trim and to the gable trim.
End wall flashing end wall flashing is applied where the upward slope of a roof meets a wall.